Digimerge DH200 Istruzioni per gli Interventi Scaricare il pdf (Pagina 149)

139

Appendix J: Replacing the Hard Drive

APPENDIX J: REPLACING THE HARD DRIVE

The system comes with a pre-installed 3.5" SATA hard drive. The system supports up to 2

terabytes (TB) of SATA storage—one 2TB 3.5" SATA HDD.

NOTE: Mak

e sure that the system is

OFF

and the power cable has been disconnected before

changing the hard drive.

Removing the Hard Drive

To remove the hard drive:

1. Remove the four short screws on the side panels of

the housing and the eight screws on the

rear panel. Keep these sets of screws separate.

NOTE: The center screw at the top of the rear panel and the screws along the audio and video ports are

longer than the other screws.

2. Carefully slide the cover away from the front panel and lift away from the housing.

NOTE: Make sure the cover is clear of all ports and connectors on the rear panel.

3. Disconnect the cables from the hard drive.

4. With one hand supporting the hard drive, remove the four mounting screws from underneath

the housing.

5. Remove the hard drive from the housing.

ATTENTION: Do not remove the two screws near the fan on the side of the housing.

Slide the cover and lift away from housing

Support the HDD and remove the mounting screws underneath the housing

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 163 164

Nessun commento

Digimerge DH200 Istruzioni per gli Interventi Pagina 149